Multi-flow calibration (MFC) is based on monitoring the analytical signal from a single calibration standard solution at several different nebulization gas flow rates (Q), which normalizes plasma conditions and minimizes matrix effects. In the present study, MFC was evaluated, for the first time, applied to inductively coupled plasma optical emission spectrometry (ICP OES) and inductively coupled plasma mass spectrometry (ICP-MS) to analyze different and complex-matrix samples. Al, As, Cd, Cr, Cu, Mn, Pb, and Zn were determined by ICP OES, while As, Cd, Co, Cu, Hg, Mo, Mn, Ni, Se, Sb, Pb, and V were determined by ICP-MS. MFC results were compared with those obtained using external standard calibration (EC) for both techniques and in all cases, MFC showed equal or superior accuracy (recoveries between 80-120%) compared to EC, and lower relative standard deviation (RSDs ≤ 10%). Several tests were also performed using only two nebulization gas flows to build linear models for calibration (called two-flow calibration, TFC) and the accurate results (recoveries ranged from 80 to 110% for ICP OES and from 81 to 102% for ICP-MS) suggests that this strategy can be also applied, resulting in a method with high sample throughput.

Over the years, laser-induced breakdown spectroscopy (LIBS) has been reported in the literature as an alternative to traditional methods of analysis, becoming well established among spectroanalytical techniques. LIBS is a technique widely used for qualitative approaches; however, it is necessary considerable effort for use in quantitative analysis, mainly due to severe matrix effects. These limitations make it difficult to broaden the application of LIBS in quantitative analysis. In this sense, this review discusses recent advances in calibration strategies applied in LIBS for minimizing matrix effects and enabling determination with satisfactory accuracy and precision. Applications, advantages, and limitations of the calibration strategies, such as matrix-matching calibration (MMC), internal standardization (IS), standard addition (SA), multi-energy calibration (MEC), one-point gravimetric standard addition (OP GSA), one-point and multi-line calibration (OP MLC), slope ratio calibration (SRC), two-point calibration transfer (TP CT), single-sample calibration (SSC), multiple linear regression (MLR), principal component regression (PCR), partial least squares (PLS) and artificial neural networks (ANN) are discussed.

This review attempts to present a broad view of the technique laser-induced breakdown spectroscopy (LIBS), since its origin, fundamentals, sample preparation strategies, use of chemometric tools for data processing, the advantages and limitations with regard to qualitative and quantitative analysis, aplications and future trends as an analytical technique that is in consolidation in analytical chemistry. LIBS is a rapid and versatile, which is able of providing qualitative and quantitative analytical information for practically any sample, in a virtually non-destructive way, without any substantial sample preparation. The instrumentation is simple, robust, compact, and enables remote analysis. The advancement of the LIBS applications in the areas of agriculture, environmental, food, biological/pharmaceutical, forensic, metallurgy and electronic waste were discussed in detail in this review. We consider that this review will be an important tool concerning dissemination of the LIBS, mainly for audience of undergraduate courses, and disciplines related to instrumental analysis.

In the present work, an inductively coupled plasma-tandem mass spectrometer (ICP-MS/MS) operating in single quadrupole and mass shift modes were evaluated for As determination in mineral fertilizers and agricultural gypsum with high contents of rare earth elements. For MS/MS mode, oxygen was the gas introduced into the octopole reaction system (ORS3). Samples were prepared by microwave-assisted digestion with diluted nitric acid solution. The accuracy was checked by analysis of a fertilizer certified reference material (NIST SRM 695) and by addition and recovery experiments. When operating in single quadrupole mode, recoveries ranged from 59 to 151%; while values obtained by MS/MS mode varied from 81 to 105% when 0.30 mL min-1 O2 was introduced into the ORS3. Limits of detection for As+ in single quadrupole and AsO+ in MS/MS mass shift mode were 6 and 9 ng L-1, respectively.

A method for determination of arsenic in mineral fertilizers by continuous flow hydride generation atomic absorption spectrometry (CF-HG-AAS) was developed by using diluted acid and digester block with perfluoroalkoxy (PFA) tubes to sample preparation. An additional sample preparation procedure using microwave-assisted digestion was evaluated and compared with the proposed procedure. A full factorial design was applied to investigate the effect of the variables and the best conditions found were 7 mol L−1 HNO3 + 30% (m/m) H2O2 as reagents, 4 h of digestion and concentration of reagents diluted 1:1. The effect of concomitants on the analytical signal of arsenic was investigated and no one significant interference was observed, with recoveries ranged from 97 to 103%. The accuracy of proposed method was evaluated by certified reference material (NIST SRM 695) and recovery of 95% was obtained. The arsenic concentration (8.9 ± 0.2 mg kg−1) found in the fertilizer is below of maximum concentration established by Brazilian legislation.

O Ministério da Saúde brasileiro determina a realização de testes sorológicos para HIV 1 e 2, HTLV I e II, HCV, HBV, T. cruzi, T. pallidum e Plasmodium nas áreas endêmicas, em todas as bolsas de coleta de sangue utilizadas no País. Entretanto, as doenças infecciosas transmissíveis através do sangue não são investigadas nos receptores de sangue (RS) antes da transfusão. Neste estudo, realizamos uma avaliação sorológica dos RS anterior à transfusão. Amostras de soro de 159 RS foram analisadas aplicando-se os mesmos testes utilizados na triagem sorológica dos doadores de sangue. Os RS foram divididos em três grupos: Grupo 1 (G1), pacientes que nunca receberam sangue, Grupo 2 (G2), pacientes politransfundidos e Grupo 3 (G3) receptores eventuais. Para a análise estatística utilizou-se o programa SPSS v.8. Valores de p<0,05 foram considerados significantes. Os resultados mostraram que 62 RS apresentaram positividade para uma ou mais doenças infecciosas transmissíveis pelo sangue. Além disso, vários RS desconheciam seu estado sorológico anterior à transfusão. A identificação de doenças infecciosas transmissíveis pelo sangue em RS anterior à transfusão poderia evitar a responsabilidade do Estado pelos RS que desconheciam ser portadores de tais doenças e apenas tiveram conhecimento de sua contaminação após a transfusão.

The Brazilian Ministry of Health has made tests for HIV1 and HIV2, HTLV I and HTLV II, HCV, HBV, T. cruzi, T. pallidum and Plasmodium in endemic areas, mandatory for all blood collection bags used in the country. However, blood-borne infectious diseases are not investigated in blood recipients before transfusion. For this study, a serological evaluation of recipients before transfusion was carried out. Prior to transfusion, serum samples from 159 blood recipients were analyzed using the same tests used in the serological screening of blood donors. The blood recipients were divided into three groups: Group 1 (G1), patients who had never received blood, Group 2 (G2), patients who had received multiple transfusions and Group 3 (G3) one-off recipients. SPSS v.8 was used for statistical analysis. Values of p<0.05 were taken to be significant. The results showed that 62 blood recipients tested positively for one or more blood-borne infectious diseases. In addition, several recipients were unaware of their serological status before the transfusion. The identification of blood-borne infectious diseases in recipients before transfusion could avoid the State being held responsible by recipients who were unaware that they were carriers of such diseases and only found out about their contamination after transfusion.